ResMed Sullivan Comfort User Manual download pdf (Page 9)

Section 3: Preparing for use

2 Switch the main switch at the rear of the flow generator on (I). Press the

START button on the front panel (see figure below).

Allow the unit to run for a few seconds, then press the STOP button.

STOP button

Front panel

3 Positioning the flow generator

• Place the flow generator on a table close to the head of your bed.

Position it carefully so that it could not be bumped from the table

during the night. Make sure that you could not trip on the power cord

when walking near the bed.

• Make sure that the area around the unit is kept dry and clean. If dust or

foreign particles are drawn into the unit it may affect treatment.

• Keep the unit well clear of articles such as clothing, bedding or towels.

If these obstruct the air inlet at the rear of the unit it may cause

overheating and damage the unit.

• Do not place the unit near a heater or a source of hot or cold air.

4 If using a water humidifier, do not position it so that water could spill from

the humidifier to the flow generator if the humidifier is bumped or over-

turned. Do not position a water humidifier on top of the flow generator.

CAUTION:  If water is spilt inside the flow generator, turn off the main

switch at the rear and unplug the unit from the power

outlet. Return the unit to your equipment supplier for

checking.

Delay timer

buttons

Pressure strip

light display

START button

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

No comments

ResMed Sullivan Comfort User Manual Page 9