ResMed Sullivan Comfort User Manual download pdf (Page 7)

Section 3: Preparing for use

Preparing for use

Assembling the mask system

The mask frame has two access

ports which should be plugged and

are not used except for initial

pressure setting by a technican. It

has a swivelling mask elbow which

allows the air tubing to be

positioned without kinks. The air

outlet vent allows exhaled air to

escape quietly.

The Modular Mask Frame (shown

right) has a detachable forehead

arm and T-Bar.

1 Before using the mask for the first time, wash the nasal cushion and air

tubing in warm water using a mild detergent. Rinse thoroughly. Hang the

tubing to dry. Wipe all surfaces of the mask frame with a clean, damp cloth

and allow to dry.

CAUTION: Do not use bleach or chlorine-based solutions to

clean the cushion, mask or air tubing. These may

cause hardening and reduce the life of the

product.

Do not hang the air tubing in direct sunlight as

the tubing may crack.

2 If you are using the Modular Mask Frame, you may need to fit the forehead

arm and optional T-Bar. Refer to the User Instructions supplied with the

Modular Mask Frame.

3 Fit the nasal cushion to the

mask frame as shown

below.

• Fit the cushion onto the

ridge of the mask frame.

The two pins on the

cushion should align with

the slots at the bottom of

the mask frame.

• Make sure the cushion is

sealed all the way around.

Optional T-Bar

Detachable

forehead arm

Access port

Swivelling

mask elbow

Air outlet vent

Modular Mask Frame

Fit nasal cushion to mask frame

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Comments to this Manuals

No comments

ResMed Sullivan Comfort User Manual Page 7

Comments to this Manuals