Resmed VPAP III & III ST User Manual download pdf (Page 17)

11Setting up the VPAP System

English

Setting up the VPAP System

Please refer to the illustrations in section D of the illustration sheet.

Setting Up The VPAP

1 Place the VPAP unit on a flat surface near the head of your bed. If the unit is

placed on the floor, ensure that the area is free from dust and clear of bedding,

clothes or any other objects that could block the air inlet.

CAUTION

Be careful not to place the device where it can be bumped or where

someone is likely to trip over the power cord.

Connect the power cord to the socket at the rear of the flow generator. Plug the

other end of the power cord into a power outlet (D-1).

WARNING

• Make sure the power cord and plug are in good condition and the

equipment is not damaged.

• The air filter cover protects the device in the event of accidental liquid

spillage onto the device. Ensure that the air filter and air filter cover are

fitted at all times.

Connect one end of the air tubing firmly onto the air outlet of the unit (D-2).

WARNING

Only ResMed air tubing should be used with your flow generator. A

different type of air tubing may alter the pressure you actually receive and

reduce the effectiveness of your treatment.

Assemble your mask system according to the mask user instructions.

Connect your mask system to the free end of the air tubing (D-3).

The VPAP system is now assembled (D-4). To start treatment, see “Starting

Treatment” on page 15.

Attaching a Humidifier

WARNING

When using a humidifier, position it lower than you, and at the same level

or lower than the VPAP.

Attaching a HumidAire 2i Humidifier

Please refer to the illustrations in section E of the illustration sheet.

The HumidAire 2i attaches to the front of the VPAP to provide heated

humidification. No other accessories are required for its use. The VPAP

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 347 348

No comments

Resmed VPAP III & III ST User Manual Page 17