ResMed S8 User Manual download pdf (Page 10)

Using the Data Card to Update Settings

If your clinician has provided a Data Card with new device settings:

1 With the device in standby mode, insert the Data Card into the slot on the Data

Card module. Updating will start automatically.

The “Card Inserted Please Wait” message is displayed on the LCD while

updating is in progress. Updating takes approximately five seconds.

The “Settings Success Remove Card” message is displayed on the LCD if the

settings were updated successfully.

Note: This message only appears once. If you re-insert the Data Card after you

have updated your settings, this message is not displayed.

Remove the Data Card from the S8 Escape II Auto.

Store the Data Card in its protective folder when not in use.

WARNING

If your clinician has told you to use this Data Card to update the settings on

your device and the “Settings Success” message does not appear, contact

your clinician immediately.

Cleaning and Maintenance

Daily

Disconnect the air tubing and hang it in a clean, dry place until next use.

Weekly

1 Remove the air tubing from the S8 device and the mask.

Wash the air tubing in warm water using mild detergent.

Rinse thoroughly, hang, and allow to dry.

Before next use, reconnect the air tubing to the air outlet and mask.

Monthly

1 Clean the exterior of the S8 device with a damp cloth and mild liquid soap.

Check the air filter for holes and blockage by dirt or dust.

WARNING

• Beware of electric shock. Do not immerse the unit or power cord in

water. Always unplug the unit before cleaning and be sure it is dry

before plugging back in.

• The mask system and air tubing are subject to normal wear and tear.

Inspect them regularly for damage.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

No comments

ResMed S8 User Manual Page 10